During the operation of the automatic production line assembly line belt, the belt slippage is often encountered. We need to find the reason and then take the solution. The common causes and solutions are as follows:
1. The motor load of the automatic production line assembly line belt is too large, causing slipping. It also protects the motor. Check the bearings and regularly clean and replace the motor lubricating oil.
2. The tail roller bearing is damaged and does not rotate or the upper and lower roller bearings are damaged too much. The cause of the damage is that the tail floats too much, and the damaged or inflexible parts are not repaired and replaced in time, which increases the resistance and causes skidding. All components should be maintained and maintained regularly.
3. When the automatic production line assembly line belt is started, the belt is separated from the roller, which causes the tension to be too small and causes the conveyor belt to slip. At this time, the belt tensioning device needs to be adjusted to increase the belt tension.
4, the automatic production line assembly line sometimes gets water or wet weather on the belt, resulting in insufficient friction between the driving roller and the belt and causing slippage. You can add some rosin powder on the rotating drum. Use a blower to blow in, avoid adding by hand.
5. When the automatic production line assembly line is started, too fast speed will also cause the belt to slip. At this time, slow down the speed to start. It can be started after two jogs to prevent slipping.